|
Put your most important radio call format up front where it counts. Made from UV and Heat stable Romark LaserLIGHTS material, the 9-Line MEDEVAC Placard will not fade, warp, or mar. Back is pre-coated with ADA Adhesive for permanant installation on any surface. Made of .005" thin flexible material to mount on irregular surfaces. Tested against abrasion and heat resistance for 2 hours at 200 degrees fahrenheit. See manufacturer's statement below for more information.
LaserLIGHTS adhesive information:
LaserLIGHTS are backed with a 1.5 mil (.0015"), acrylic pressure sensitive adhesive designed for industrial applications. The adhesive has excellent exterior properties and resistance to water, solvents and extreme temperatures. It bonds extremely well to metals, plastics, rubbers and foams. The adhesive has good initial tack, and fully sets up over 72 hours.
Typical applications in which this adhesive is used include: nameplates, electronics, appliances, recreational vehicles, computers, packaging, aviation and automotive.
LaserLIGHTS Durability and Weatherability information:
LaserLIGHTS surface durability is about twelve times greater than that of a conventional microsurfaced engraving plastic. On an RCA Taber Abrader CS17 set at 500 gm, there was no wear through to the substrate after a minimum of 70 cycles.
LaserLIGHTS and their adhesive withstand high temperatures, up to 250˚F (121˚C) for intermittent and 200˚F (93˚C) for coninuous use. In specific applications they have been successful at considerably higher temperatures.
|
|
